milifriends.blogg.se - Ipad sycing mimolive issues

#Ipad sycing mimolive issues full
#Ipad sycing mimolive issues pro
#Ipad sycing mimolive issues verification

This seems to happen after a couple of hours from a fresh boot.I tried to reduce the NDI bandwidth of the cameras (default is 140MB, I tried 100MB).The IP range of the cameras and the Mac is the same (10.0.10.x).I tried to change the dock (Caldigit TS3 and TS4).So it means the NDI feed coming from the cameras is still good. perhaps most importantly, if I launch NDI Video Monitor on a second Mac (on the same network), I can correctly access the 2 camera directly in NDI.In the same way, the PTZ controller (hardware from Birddog, or PTZ layer in Mimo) will still work, as the cameras are moving.When this happens, the cameras are indeed still working: I connected an HDMI cable to each camera and I can see the image correctly, meaning only the NDI live feed is the problem.

#Ipad sycing mimolive issues full

If I quit Mimo and launch it again, it’s not solved: only a full reboot will make the pictures live again. When that happens, in the source panel I can see the IPs grayed out in the source cameras (NDI sources), and of course I see black on the Video Switcher preview layer. On some dry runs of many hours in test mode, we ran into some problems.įrom time to time, the live feed will disappear on Mimo. The mimolive test project is very simple, with just a few layers with slides, and a Video Switcher layer for switching the two cameras.

#Ipad sycing mimolive issues pro

Mimolive 6.0.2 runs on a MacbookPro M1 2021 (16"), M1 Pro 10 core, 16GB ram.Ī CalDigit TS3 thunderbolt dock is ensuring connection for ethernet and also USB for the iPad (running Mimo Remote). Power is provided directly via PoE, and the cameras are only connected via NDI. The setup is straightforward: 2 cameras connected via CAT6 to a PoE+ switch. Keep us posted with what happens from here.I’m trying a simple setup with some new Birddog P200 PTZ cameras we got. Add a check to your phone number and email address. Make sure that the Apple ID shown here is the same Apple ID that you're using on your other devices. Click Accounts, then select your iMessage account. On Mac, open Messages, then choose Messages > Preferences.

#Ipad sycing mimolive issues verification

If you're not using two-factor authentication for your Apple ID, a verification code appears on each of your other devices: enter that code on your iPhone.

On iPhone, go to Settings > Messages > Text Message Forwarding, then choose which devices to allow to send and receive text messages from this iPhone.

Add a check to your phone number and email address, so that you can be reached by iMessage at both. Make sure that the Apple ID at the top of the screen is the same Apple ID that you're using for iMessage on your other devices.

On iPhone, go to Settings > Messages > Send & Receive.

Each device is signed in to iCloud with the same Apple ID.

Make sure that your devices are set up as follows: Use this feature with any Mac, iPhone, iPad, or iPod touch that meets the Continuity system requirements. Specifically, follow the steps in this section to check Messages settings on all of your devices: Use Continuity to connect your Mac, iPhone, iPad, iPod touch, and Apple Watch - Apple Support The following support article provides some relevant troubleshooting steps to try for this issue: Thank you for using Apple Support Communities! I understand that messages from other devices are not syncing to your iPad.